For under headers - between our 724 7241 rails

This is a blank low flow tank with a 1/4 " NPT flange for a drain cock.

Matches 719 Bottom Tank

Right side bottom mounting bracket.

Left side bottom mounting bracket.

This tank is similar to tank719, except the 3.00 " diameter hose connection is curved back and up toward the engine.

This tank has a 1.25 " diameter hose connection, and a 3/8 " NPT flange. There is a cut-out in the center of the tank to accommodate a PTO.

This tank has a 2.50 " hose connection that points downwards then bends at a 90 degree angle towards the engine, and a 1/2 " NPT flange for a drain cock. Note: this tank shares a bolt pattern with tank #PB 511 and tank #PB 800.

This tank has a 2.50 " hose connection that points downward then angles at 90 degrees towards the driver side. There is a 1/4 " NPT flange at the bottom of the hose connection, and a PTO cutout in the center of the tank. Note: this tank shares a bolt pattern with tank #PB 511 and tank #PB 800.

This tank has a 3.00 " hose connection, 11.50 " from the edge of the tank to the center of the hose connection. The connection comes first straight down out of the tank, then bends at 90 degrees to face the engine. This tank is similar to the PB 7195, except that the hose connection does not sweep upward. Note: this tank shares the bolt hole pattern with tank #PB 719 and tank #PB 708.

2 Mounting Holes @ 8.62 " Centers; Fits Peterbilt Bottom Tank # PB719; This bracket is 2.25 " Deep

Top and bottom flanges each have 12 holes, ten drilled clearance for 5/16 " bolts and two tapped 5/16 " N.C. One bracket on side of channel near top with two holes drilled clearance for 1/2 " bolts. Angle brackets on each side of channel with 1/4 " N.C. threaded holes. Note: frames are not interchangeable. Order left or right accordingly.

Top and Btm flanges each have 12 holes, 2 tapped 5/16 " NC and 10 drilled clearance for 5/16 " bolts. Engine side of rail is flush with flanges with seven 1/4 " NC threaded holes. Six 1/4 " NC threaded holes on side. Two brackets on rail - one for CAC and one for mounting pin. NOTE: Frames are not interchangeable. Photo shown is Left side

2.25 " hose connection, 2.75 from end of tank to center of connection

Top and bottom tanks both have 2.50 " diameter hose connections, the top connection is in the center of the tank, and the bottom connection is 4.00 " from the end of tank to center of the hose connection.